Dräger SpO2 Extension Cable, 2 m, for Vista Monitors

This is a 2 m SpO2 extension cable for Dräger Vista patient monitors. It sits between the SpO2 sensor lead and the monitor's oximetry input, extending the run so the monitor can be sited away from the bed, on a trolley or on a wall bracket, without straining the sensor lead. The extension also takes the connect and disconnect cycles that would otherwise wear the sensor's own connector.

It is a reusable cable, cleaned between patients as set out in the device instructions for use. The cable is used in intensive care, neonatal intensive care and the operating room across adult, paediatric and neonatal patients. It fits the Vista 120 A, Vista 120 C, Vista 120S A, Vista 120S C, Vista 120 SC Model A, Vista 120 SC Model B, Vista 300 Model A and Vista 300 Model C monitors.

Note that the Vista 120 and Vista 120S variants without the '+' designation take a different sensor and cable range from the '+' models, so confirm the monitor variant before ordering. The item is ordered against its Dräger part number, and the GTIN listed in the specifications below can be used to confirm the reference before an order is raised.

Where the part is supplied in a pack or box, the pack is the ordering unit, so state the number of packs rather than the number of individual pieces on your enquiry. HumaNova supplies Dräger parts and accessories to hospitals, clinics and laboratories across the UAE and the wider GCC, and works from the part number, the device model it is destined for and the quantity required.

Pricing for this item is issued by request for quotation rather than published, so send those three details through the enquiry form or to the HumaNova sales team and a written quotation will be prepared against your specification. If you are unsure whether this reference matches the device generation or variant you hold, include the model and serial details with the enquiry and the compatibility will be checked before the quotation is issued.